How to do a bucket test
Put a bucket marked at 1 gallon under the tap or shower, turn the water on as you normally use it and time how many seconds it takes to fill to the mark. A bigger bucket gives a steadier reading for a hose or outdoor tap: enter its size and the time.
Source Virginia Cooperative Extension · Energy Series: What about the Bathroom? (BSE-303NP) ↗
How to calculate gallons per minute
Here it is with your numbers:
- Minutes: 24 ÷ 60 = 0.4 min.
- Flow: 1 ÷ 0.4 = 2.5 gallons per minute.
It means 150 gallons an hour at this flow: a 5-gallon bucket fills in 120 seconds.
Source NIST Handbook 44 (2026) · Appendix C, General Tables of Units of Measurement ↗
Is my shower low-flow?
New showerheads may be rated at no more than 2.5 gallons per minute at 80 psi, and a WaterSense-labeled showerhead at no more than 2.0 gpm. Virginia Cooperative Extension says that if a gallon fills in under 20 seconds, you could benefit from a low-flow showerhead.
| Shower flow | What it means |
|---|---|
| 2.0 gpm or less | The WaterSense level for showerheads |
| 2.01 – 2.5 gpm | Within the federal maximum for showerheads |
| Over 2.5 gpm | More than a new showerhead may be rated |
A home reading is a rough check: your water pressure may be lower or higher than the 80 psi the rating uses.
Source EPA WaterSense · Specification for Showerheads, Version 1.1 ↗
FAQs
How do you calculate GPM?
Divide the gallons by the minutes. Time how long a container takes to fill, change the seconds to minutes (divide by 60), then divide: 1 gallon in 24 seconds is 1 ÷ 0.4 = 2.5 gallons per minute.
Source Virginia Cooperative Extension · Energy Series: What about the Bathroom? (BSE-303NP) ↗
How do I calculate the GPM of a 5-gallon bucket?
Time how many seconds it takes to fill, then work out 5 ÷ (seconds ÷ 60), or 300 ÷ seconds. A 5-gallon bucket that fills in 60 seconds is 5 gpm; in 100 seconds, 3 gpm.
How to measure water flow rate with a bucket?
Use a bucket marked at 1 gallon, run the water at the pressure you normally use and time how long it takes to fill to the mark. Virginia Cooperative Extension says a shower that fills a gallon in under 20 seconds (more than 3 gpm) could benefit from a low-flow showerhead.
What is 1 gpm equal to?
60 gallons an hour, or 3.79 liters a minute (1 gallon is 3.785411784 liters).
Source NIST Handbook 44 (2026) · Appendix C, General Tables of Units of Measurement ↗
How to convert gallons per minute to gallons?
Multiply by the minutes. 2.5 gallons per minute for 10 minutes is 25 gallons; for an hour, 150 gallons.
Sources
- Virginia Cooperative Extension: Energy Series: What about the Bathroom? (BSE-303NP)
- EPA WaterSense: Specification for Showerheads, Version 1.1
- NIST Handbook 44 (2026): Appendix C, General Tables of Units of Measurement